Solved I require some help with BP editing
- Thread starter The Satirical Gamer
- Start date
Open your file app, then follow this path:
internal storage- android- data- com.stefmorojnaspaceflightsimulator- files- saving- blueprints.
Under each part subsection in the file, there is an area with the parts x and y. change these to move the part around. (one block is 0.5) Keep in mind that you can clip parts using this as long as they are both connected together.
Below that there is an x, y, and z value. adding to x makes the part larger on the x axis, and y makes it larger on the y. If you write a negative, it flips 180 degrees. Decimals don't work. You can never make a part smaller than it allready is. Anyway, the Z is the angle. so when Z=15 the part is angled at 15 degrees. Sometimes when putting parts at angles, they wont connect, just try z=10, 15, or20. Oh, and a tilted part can still connect to a non- tilted one. Good luck!
internal storage- android- data- com.stefmorojnaspaceflightsimulator- files- saving- blueprints.
Under each part subsection in the file, there is an area with the parts x and y. change these to move the part around. (one block is 0.5) Keep in mind that you can clip parts using this as long as they are both connected together.
Below that there is an x, y, and z value. adding to x makes the part larger on the x axis, and y makes it larger on the y. If you write a negative, it flips 180 degrees. Decimals don't work. You can never make a part smaller than it allready is. Anyway, the Z is the angle. so when Z=15 the part is angled at 15 degrees. Sometimes when putting parts at angles, they wont connect, just try z=10, 15, or20. Oh, and a tilted part can still connect to a non- tilted one. Good luck!
